Board Setup

What can I put behind my dart board to protect the wall?

Protect the wall with a surround, a plywood backboard, cork or foam. Learn which backings catch darts, how wide to cover and what to avoid.

On this page
  1. The short answer
  2. Surrounds: the first line of defence
  3. Backboards: the widest cover
  4. Cork, foam and carpet
  5. How far the backing should reach
  6. What to avoid
  7. Floor protection
  8. Soft-tip boards
  9. Mistakes to avoid

The short answer

Put a surround around the board, and if you can, a plywood backboard behind it. Foam and carpet also work well. Thin cork and hard surfaces are weaker choices, because they let darts through or bounce them back.

Surrounds: the first line of defence

A surround is a ring of EVA or polyurethane foam around the edge of the board. It catches darts that land just outside the scoring area. The outer diameter is roughly 28 to 30 in (71 to 76 cm), and it varies by model. A surround protects the wall around the board, but it does not stop every miss. Very wide throws still reach the wall.

Backboards: the widest cover

A backboard is a square of plywood or MDF, usually 12 to 18 mm thick, often painted or covered. Fix it across the studs so it can carry the board’s weight. A backboard gives the widest coverage, and it can be combined with a surround for the best protection. See the plasterboard guide if your wall needs fixings first.

Cork, foam and carpet

  • Cork board or cork tiles: cheap and good at absorbing darts. Thin tiles, under about 10 mm, let darts reach the wall, so choose thicker cork or fix it to a backboard.
  • Foam backboards or panels: EVA or polyethylene foam catches darts and is light.
  • Carpet offcut or carpet tiles: a traditional pub solution. Fix them to a backboard rather than straight to the wall.

How far the backing should reach

As a rule of thumb, cover at least 30 cm (12 in) beyond the edge of the board in every direction. Beginners tend to miss wider than they expect, so a larger area is safer. A surround plus a backboard that extends past it gives the most protection.

What to avoid

  • Hard surfaces such as tiles or metal. Darts bounce off them and can blunt the points, and they add bounce-outs.
  • Thin cork alone. It is not enough to stop steel tips.
  • Relying on a surround alone for wide throws. Add a backboard if you play often.

Hard backings increase bounce-outs, so keep spectators out of the lane while anyone is throwing.

Floor protection

A dart mat or oche mat protects the floor and the points of your darts from bounce-outs. It also marks the throw line. For the line itself, see the oche distance guide.

Soft-tip boards

Soft-tip boards have a built-in catch ring, but they still benefit from wall protection, especially if you throw wide or play often. A cabinet or surround also works well with them. The cabinet and surround guide covers the fitting steps.

Mistakes to avoid

  • Thinking a thin cork tile fully stops steel tips. Use thicker cork or a backboard.
  • Thinking a surround covers every miss. Wide throws still reach the wall.
  • Thinking hard surfaces are good backing. They bounce darts and blunt points.
  • Thinking a backboard moves the throw line. Measure the throw distance from the board face. See the dartboard setup guide.

The complete guide to board setup

How to Set Up a Dartboard: Height and Throwing Distance
Read the guide

Keep exploring

Guides from other topics

All topics →