Board Setup

Dartboard Height: Regulation Measurements in Metres and Feet

The regulation dartboard height is 1.73 m (5 ft 8 in) to the bull centre. Learn to measure to the bull rather than the bracket, in metres and feet.

On this page
  1. The regulation height
  2. Measuring to the bull, not the bracket
  3. Where the top and bottom of the board sit
  4. The same height for steel tip, soft tip, men, women and juniors
  5. Wheelchair and adapted formats
  6. Measuring from the finished floor
  7. Mistakes to avoid

The regulation height

The regulation bull height is 1.73 m (173 cm), measured from the floor to the centre of the bullseye. In imperial units, that is 5 ft 8 in, or 68 inches.

Converting 5 ft 8 in gives 1.727 m, which is normally rounded to 1.73 m. Do not round it down to 1.70 m.

Measuring to the bull, not the bracket

Measure from the floor straight up to the centre of the bullseye. Mark that point on the wall first, then work out where the bracket goes.

The bracket is not at the bull’s height. Where it sits depends on the mounting kit and whether the board hangs from its centre or its top. If you mark the bracket at 1.73 m, the bull will end up in the wrong place.

Where the top and bottom of the board sit

A regulation bristle board is 451 mm (17¾ in) across, so its radius is about 225 mm. With the bull at 1.73 m:

  • the top of the board sits at about 1.96 m (6 ft 5 in) from the floor
  • the bottom of the board sits at about 1.50 m (4 ft 11 in) from the floor

Cabinets and surrounds reach higher, so check the clearance under low ceilings or beams.

The same height for steel tip, soft tip, men, women and juniors

The same bull height applies to steel-tip and soft-tip boards. Under WDF and PDC rules, it also applies to men, women and juniors. Do not lower or raise the board to suit a shorter or taller player. The height is the same for everyone so the game stays fair.

Wheelchair and adapted formats

Wheelchair darts use a lower bull, about 1.37 m (4 ft 5¼ in). The exact figure varies between organisations, so check the rules of the event you are playing in. For a standard home board, use 1.73 m.

Measuring from the finished floor

Measure from the floor as it will be when you play. If you put a thick mat or carpet down later, the starting point changes, so measure again once the floor is finished.

Mistakes to avoid

  • Measuring to the top or bottom of the board. The bull is the reference point.
  • Marking the bracket as the bull height. The two are different.
  • Rounding 5 ft 8 in down to 1.70 m. The figure is 1.73 m.
  • Adjusting the height for a shorter or taller player. The regulation height is the same for everyone.
  • Assuming the bracket height equals the bull height. It depends on the kit.

Once the bull is at the right height, set the throw line next. Oche distance explains where to stand, and how far it is from a dart board covers the diagonal check. The full sequence is in the dartboard setup guide.

The complete guide to board setup

How to Set Up a Dartboard: Height and Throwing Distance
Read the guide

Keep exploring

Guides from other topics

All topics →