Can you put a dartboard on plasterboard?
Yes, but not on plasterboard alone. Plasterboard is thin, usually 12.5 mm (about ½ in), and it cannot take the repeated impact of darts. A bristle board is also heavy enough that the fixings need to carry a steady load, and every dart that lands adds more.
The safe approach is to fix into a stud or a timber noggin, or to spread the load with a backing board across two studs. If neither is possible, use heavy-duty cavity fixings rated for the job.
Find the studs first
Use a stud finder before you mark anything. Studs in UK walls are usually spaced at 400 mm or 600 mm centres. In the US, the usual spacing is 16 in or 24 in. If you find a stud near your bull mark, you may be able to fix the bracket straight into it.
Metal studs need self-tapping screws or fixings made for metal studs. Timber screws will not grip them well.
Option 1: screw into a stud or noggin
This is the strongest option when the stud falls where you need it. Drill pilot holes, use screws long enough to bite well into the timber, and tighten them until the bracket is firm. Do not overtighten, because that can crush the board around the fixing.
Option 2: a backing board across two studs
A plywood backboard, about 12 to 18 mm thick, screwed across two studs spreads the load and protects the wall. The bracket then fixes to the board rather than the plasterboard. This is also the easiest way to cover the wall around the board, so a surround or backboard can sit on the same panel. For ideas, see what to put behind a dartboard.
Option 3: heavy-duty cavity fixings
When there is no stud at the right spot, cavity fixings are the next choice. Common types include spring toggles, metal hollow-wall anchors and GripIt-style fixings. Their ratings vary a lot between brands, so check the packaging for the shear rating and make sure it covers the weight of the board plus dart impacts.
Why standard plastic plugs fail
Plastic wall plugs designed for masonry are made for solid material. In plasterboard, they grip only the thin skin, so they pull out under load. A single plastic plug will not hold a dartboard, however carefully it is fitted.
Fix the bracket and check the bull height
Mark the bull at 1.73 m (5 ft 8 in) from the floor, then fix the centre bracket so the bull sits at that height. Fit the stabilising brackets at the edge of the board so it cannot rotate. Check the level before you tighten everything. The dartboard height guide explains why the bracket and the bull are different heights.
How the board is laid out
Once the board is up, the segments are arranged in a fixed number order. The 20 sits at the top, centred above the bull. Going clockwise from the top, the numbers run:
20, 1, 18, 4, 13, 6, 10, 15, 2, 17, 3, 19, 7, 16, 8, 11, 14, 9, 12, 5
The 6 sits at 3 o’clock, the 11 at 9 o’clock and the 3 at the bottom. The levelling guide uses these positions to check the board is straight.
Safety: cables and pipes
Scan the wall for cables and pipes before you drill. Take extra care above and below sockets and switches, where cables usually run. Overtightening cavity fixings can crush the plasterboard, so stop when the fixing is firm.
Mistakes to avoid
- Using a single plastic plug. It will pull out.
- Choosing a spot without checking for studs or services.
- Ignoring the impact load. Darts add repeated force, not just the weight of the board.
- Assuming a surround stops all damage. Plasterboard dents easily around the edge of a surround, so a backboard helps.
For the rest of the setup, see the dartboard setup guide.