Where to stand for steel-tip darts
For steel-tip darts, the regulation distance is 2.37 m (7 ft 9¼ in). Measure horizontally from the face of the board to the front edge of the oche. Soft-tip boards usually use 2.44 m (8 ft), though some leagues and machine operators set it differently.
What the oche (throw line) is
The oche, pronounced “ockey,” is the throw line. It is also called the toe line. Your feet must not touch or cross its front edge while you throw. You can lean over the line to reach the board, as long as your feet stay behind it.
Some venues use a raised strip for the oche. At home, a strip of tape, a fixed batten or a flat oche mat does the same job.
The same distance for women, men and juniors
The 2.37 m distance is the same for women under WDF and PDC rules. There is no separate ladies’ line, so a woman playing at a standard board stands at the same spot as a man.
Juniors normally use the same distance too. Some local youth leagues shorten it, so check the rules of the league you are playing in.
Stance: where to put your feet
Players use a few common stances, which the darts technique guide covers alongside grip and release:
- Side-on: the body turns so the throwing shoulder faces the board.
- Front-on: the body faces the board more directly.
- Angled: about 45 degrees, which many players find a good middle ground.
Most players put their dominant foot forward. Many line their front foot up with the bull or with the segment they are aiming at. Whichever stance you pick, keep your weight behind the line.
Standing to the side of the oche is generally allowed if your feet stay behind the imaginary extension of the line. Check the rules of your event, because this varies.
Marking the line at home
Measure 2.37 m from the face of the board, not from the wall. Mark the line square to the board, on a flat floor. A tape line, a fixed batten or an oche mat all work. If you use a raised strip, make sure it is fixed down, because a raised edge is a trip hazard.
The dartboard setup guide covers the rest of the setup, including the bull height.
Mistakes to avoid
- Measuring from the wall. The board is about 38 mm (1½ in) thick, and the measurement should start at the board face.
- Thinking women or beginners get a shorter standard distance. The regulation distance is the same for everyone.
- Thinking leaning over the oche is a foul. Only your feet need to stay behind the line.
- Treating the diagonal as the throw distance. The diagonal from the bull to the oche is about 2.93 m. It is a check, not the line you mark. How far it is from a dart board explains the check.
- Assuming soft tip and steel tip use the same line. Soft tip is usually 2.44 m.
Older pub distances of 7 ft, 7 ft 6 in, 8 ft and 9 ft still turn up. If you are playing on a board you did not set up, measure it rather than assuming. For room planning, see how much space you need.