Rules

Soft-Tip and American Darts Rules Explained

Soft-tip darts use plastic tips and electronic boards that score automatically. Here are the common rules, machine settings and how US organisations differ.

On this page
  1. The short answer
  2. Soft-tip and steel-tip at a glance
  3. Equipment and setup
  4. How scoring works on an electronic board
  5. Common games: 501 and cricket
  6. American darts and US organisations
  7. Common misconceptions
  8. Safety
  9. Where to go next

The short answer

Soft-tip darts have plastic tips and are thrown at an electronic board, which scores each dart automatically. The rules are set by leagues and organisations, so they vary from place to place. Common games are 501 and cricket, and the throw line is often 8 ft (2.44 m) from the board. Steel-tip darts must never be thrown at an electronic board.

Soft-tip and steel-tip at a glance

Feature Steel-tip Soft-tip
Tip Metal Plastic
Board Bristle (sisal) Electronic, with plastic segments full of small holes
Scoring Read by the players Machine scores automatically
Usual throw line 2.37 m (7 ft 9 1/4 in) Often 2.44 m (8 ft); some leagues use 2.37 m
Usual weight limit Up to 50 g (WDF) Often 18 to 20 g, depending on the organisation
Board height 1.73 m to the bull centre 1.73 m to the bull centre; some makers list 1.72 m

Equipment and setup

  • Tips: plastic tips only. Replace broken tips.
  • Weight: most leagues cap a soft-tip dart at around 18 to 20 g. Some organisations allow up to about 24 to 25 g on certain machines. Check your league’s limit.
  • Throw line: 2.44 m (8 ft) is the usual US soft-tip standard. Some leagues use 2.37 m (7 ft 9 1/4 in), and the league’s rules decide. For measurements, see the regulation dartboard height.
  • Never use steel-tip darts on an electronic board. They can damage it.

How scoring works on an electronic board

The machine registers each dart when it lands in a segment, adds the score and shows the total.

  • Registered darts count. A dart that registers and bounces out usually still counts. League rules set the detail, so check them.
  • Unregistered darts score nothing. A dart that sticks in the board but does not register normally scores zero.
  • The machine’s score is usually final. A manual correction needs the league’s or the opponent’s agreement, depending on the rules.
  • Wait for the prompt. Wait for the machine to finish registering and prompt you before throwing. Then retrieve your darts and press the change-player button if the machine needs it.

Bull settings

Many machines score both bull rings as 50 points, which is called a “fat bull”. A “split bull” setting scores the outer ring as 25 and the inner as 50. The setting depends on the machine and the league, so check it before you start.

For cricket, the outer bull usually counts as one mark and the inner bull as two marks, but the machine setting can vary.

Common games: 501 and cricket

501 and the out rule

Soft-tip 501 uses the same countdown as steel-tip. The out rule is set by the league:

  • Open out: any score can finish the leg.
  • Double out: the last dart must land in a double or the bull.
  • Master out: the last dart can be a double, a treble or the bull, depending on the rules.

Going below zero, or leaving 1 when a double or master finish is needed, is a bust. The score goes back to what it was before that visit.

Cricket

Players aim for the numbers 15 to 20 and the bull. Each number needs three marks to close: a single is one mark, a double is two and a treble is three. Once you close a number, you score on it while your opponent has not closed it. The first player to close all their numbers, with equal or more points, wins.

American darts and US organisations

Two organisations come up often in US play:

  • National Dart Association (NDA): publishes soft-tip rules that many leagues follow.
  • American Darts Organization (ADO): runs amateur leagues and tournaments in the US, covering steel-tip and soft-tip.

Most US dart players play the traditional games described above, such as 501 and cricket. “American darts” can also name a regional game. Wikipedia describes a board style found mostly in parts of eastern US states, including Pennsylvania and New Jersey. Its rules vary by region, so check locally.

The NDA, ADO and local leagues differ on the bull, the out rule and the throw line. Check the rulebook your league uses.

Common misconceptions

  • “Soft-tip rules are the same everywhere.” They are not. The NDA, ADO and local leagues differ.
  • “The machine’s score is always right.” It is usually final, but leagues set the rules for corrections.
  • “The throw line is the same as steel-tip.” It is often 8 ft for soft-tip, but not always.
  • “Steel-tip darts are fine on an electronic board.” They are not.

Safety

Broken plastic tips can leave sharp stubs in the board. Remove them carefully with pliers, and check the board before you throw.

Where to go next

The complete guide to rules

Darts Rules: How the Game Works From Throw to Checkout
Read the guide

Keep exploring

Guides from other topics

All topics →