The short answer
The regulation height is 5 ft 8 in (1.73 m) from the floor to the centre of the bull. Most sources give the same height for steel-tip and soft-tip boards.
The throw line, called the oche, is 7 ft 9 1/4 in (2.37 m) from the face of a steel-tip board. Soft-tip throw lines are often 8 ft (2.44 m).
Measuring the height
- Measure from the floor to the centre of the bull, not to the top or bottom edge of the board.
- Mount the board so it sits level and does not rotate. A board that turns on its bracket changes where the 20 sits.
- Some electronic board makers list a slightly different figure, such as 1.72 m. If your board came with a manual, follow its figure.
The World Darts Federation uses 1.73 m as its standard for play. The height is often described as roughly eye level for a tall adult.
How far should you stand from a dartboard?
The standard steel-tip distance is 2.37 m (7 ft 9 1/4 in), measured horizontally from the face of the board to the front of the throw line. Soft-tip distances are often 2.44 m (8 ft), but some leagues use 2.37 m, so check your league before you mark the floor.
Steel-tip and soft-tip figures
| Measurement | Steel-tip | Soft-tip (electronic) |
|---|---|---|
| Bull centre to floor | 1.73 m (5 ft 8 in) | 1.73 m (5 ft 8 in); some makers list 1.72 m |
| Throw line from board face (horizontal) | 2.37 m (7 ft 9 1/4 in) | Often 2.44 m (8 ft); some leagues use 2.37 m |
| Bull centre to throw line (diagonal, at floor level) | About 2.93 m (9 ft 7 3/8 in) | About 2.99 m (9 ft 9 5/8 in) |
Measuring from the face of the board
Measure from the face of the board, not from the wall. A board is about 1.5 in (38 mm) thick, and a cabinet or surround adds more depth. If the board projects from the wall, move the throw line back by the same amount.
One simple method is to drop a string or plumb line from the face of the board to the floor, then measure from that point.
The diagonal check
The diagonal measurement runs from the centre of the bull to the throw line at floor level. It is a useful cross-check on the horizontal figure. Someone holding the tape at the bull makes it easier, or you can use a measuring tool that anchors on a dart in the board.
Setting up at home
- Mount the bracket into a stud if you can. Use heavy-duty anchors if you cannot.
- Hang a backboard or surround to protect the wall and floor from bounce-outs.
- Mark the throw line on the floor, or use a mat or line that fixes the distance so it does not drift.
- If the board wobbles, adjust the centre screw until it sits firm.
Common mistakes
- Measuring the height to the top edge or the bottom edge of the board.
- Measuring the throw line from the wall rather than the face of the board.
- Lowering the board for women. Standard rules use the same height for all players.
- Assuming a soft-tip setup uses the same throw line as a steel-tip one. The two often differ.
Some organisers adapt the board height for wheelchair or junior play. Those adaptations are set by the organiser, not by the standard.
Where to go next
- Darts rules from throw to checkout covers the full game.
- How to set up a dartboard walks through mounting the board and marking the throw line.
- Soft-tip and American darts rules covers electronic boards in more detail.
- Pub darts league rules explains the throw lines used in many leagues.