The short answer
A dart that touches a wire scores the segment where its point is embedded. The wire itself has no value. If the call is unclear, the referee or scorer decides from where the point entered the board. A dart that hits a wire and bounces out scores zero.
What the wire is and what it scores
The wires are the thin metal dividers that split the board into segments and rings. They run from the centre to the outer edge. A wire is not a scoring area of its own, so a dart that lands on a wire does not score a “wire” value.
The scoring areas are the segments between the wires: singles, doubles and trebles. So the question is always which area the point is in.
Where the point lands decides the score
The score is decided by where the point enters the board, not by the flight of the dart or the position of the barrel. A dart leaning on a wire scores the area its point sits in.
Examples
| Where the point sits | Score |
|---|---|
| Inside the large single area of the 20 | 20 |
| Inside the thin treble ring of the 20 | 60 |
| Inside the thin double ring of the 20 | 40 |
| Clearly on one side of a wire, in a single area | That single area’s value |
| Outside the outer wire | 0 |
If the point sits in the wire itself and it is not clear which side it is on, the referee decides.
Doubles, trebles and the wire
A dart that touches the double wire does not automatically count as a double. The point has to sit inside the double ring. The same applies to the treble ring.
When the call is unclear
Close calls are normal, especially where the point sits on a line. The referee or scorer looks at where the point entered the board. In many events, the referee’s decision settles the matter.
Players should leave darts in the board until the score is agreed. The point’s position is needed to settle a close call, and pulling the darts out early can make that harder.
Wires and bounce-outs
A dart that hits a wire can deflect and bounce out. On a steel-tip board, a bounce-out scores zero and is not rethrown. So a wire can affect both where a point goes and whether the dart stays in the board.
For the full rule, see bounce-outs in darts.
Players often describe round wires as causing more bounce-outs than thin blade wires. That is a common experience rather than a measured result, so treat it as a rule of thumb.
Soft-tip boards
Electronic boards do not read the wire the same way. The board has sensors for each segment. A dart that hits a segment divider registers as one segment, as the other, or not at all. The machine’s reading usually settles the score, unless league rules allow a correction.
For more on electronic scoring, see soft-tip and American darts rules.
Keeping the wires in good shape
- Keep the wires tight. A loose wire moves, which changes where darts land and how they bounce.
- Consider a staple-free board. With no staples in the scoring area, there is less to deflect a dart.
- Rotate the board regularly so wear spreads across the segments. Many players do this.
- Replace or tighten the spider if it moves.
Common misconceptions
- “A dart on a wire scores the higher segment.” It scores the segment its point sits in.
- “A dart on the double wire is a double.” It has to sit inside the double ring.
- “Wire hits are rethrown.” Under the standard rules, they are not.
- “The angle of the flight decides the score.” The point decides it.
Where to go next
- Darts rules from throw to checkout covers the full game.
- Bounce-outs in darts: do they count? explains what happens when a dart falls out.
- Soft-tip and American darts rules covers electronic boards.