Board Layout

Dartboard Wires: What They're Made Of and Why They Matter

Dartboard wires are steel, forming a spider that divides the scoring areas. Learn the wire types, how wire affects bounce-outs and when to replace a board.

On this page
  1. What wire is made of
  2. The spider: radial and circular wires
  3. Wire types
  4. Why wire matters for bounce-outs
  5. Loose and bent wire
  6. When a dart lands on a wire
  7. Caring for the board

Dartboard wires are steel. The radial wires and the circular wires together form a structure called the spider, which marks out the scoring areas.

What wire is made of

Dartboard wire is high-tensile steel, and many wires are coated to resist rust. Traditional boards were wired by hand. Patrick Chaplin’s account of an early Yorkshire workshop describes wire set by hand, using different gauges for the segments and the rings, and held in place with staples.

The spider: radial and circular wires

  • Radial wires. Twenty wires run out from the centre and divide the board into its 20 segments.
  • Circular wires. Wires run round the double ring, the treble ring and the two bulls, marking the edges of each scoring area. The rings guide explains how the circular wires are counted.

Wire types

Reviewers mention three kinds of wire:

  • Thick wire, which can cause bounce-back.
  • Angled wire, which one reviewer said sends darts into the bed.
  • Thin, knife-edge wire, which reviewers said helped cut bounce-back.

Why wire matters for bounce-outs

Wire affects how often a dart bounces out.

  • Bounce-outs score nothing. A dart that bounces off the wire or out of the board does not score.
  • Rethrows are not allowed. Under standard rules, a dart that bounces out cannot be thrown again. Darts501’s Yorkshire rules say the same, and that only darts touching the scoring area count.
  • Thick wire can cause bounce-back. A review of one board with thick wiring found this.
  • Thinner wire leaves more scoring area. The double and treble rings are only 8 mm wide, so thin wire takes up less of each bed.

Loose and bent wire

  • Loose or bent wire can cause more bounce-outs.
  • Do not pry bent wire with your fingers. The ends can be sharp.
  • Repairs are often impractical. Replacing the board is often easier than repairing damaged wire.

When a dart lands on a wire

The rules for a dart that lands on a wire vary, so check your league’s rules before a match.

Caring for the board

  • Rotate the board to spread wear across the segments. Players commonly do this.
  • Keep the board dry. Damp is bad for both sisal and wood.

For how the rings sit around the wires, see the rings and bullseye guide. For smaller boards, see the mini board comparison.

The complete guide to board layout

Dartboard Layout: Numbers, Rings and Dimensions
Read the guide

Keep exploring

Guides from other topics

All topics →