The Yorkshire dartboard is a traditional regional board from England. It uses the same 20 numbers in the same order as the standard board, but it has no treble ring. Its scoring is limited to singles, doubles and a bull.
What the Yorkshire board is
The board was played in pubs across Yorkshire. Patrick Chaplin, a historian of pub games, writes that it held on in many leagues into the 1970s before most adopted the London board. Its top single-dart score is the 50 bull, and its top three-dart score is 150, from three bulls. The standard board’s top three-dart score is 180, from three treble 20s.
Who designed the numbering
The Yorkshire board uses the standard numbering. Chaplin’s research credits Thomas William Buckle, a craftsman from Dewsbury who later worked in Leeds, with that order. His account says Buckle converted a London Fives board into a 20-segment board, using the numbers in the standard order, and sold boards to local pubs. By 1910 he had a workshop in Dewsbury. Chaplin describes the early boards as made from Dutch elm and wired by hand, with staples fixing the wire.
The order is often credited to Brian Gamlin, a Lancashire carpenter. Chaplin found no contemporary record of Gamlin. The why article weighs up the two claims.
How the Yorkshire board differs
- No treble ring. The board has singles and doubles, not trebles.
- One bull, worth 50. Chaplin’s account says the outer 25 bull and the treble ring were added to the London board between 1918 and 1924, by someone he has not identified. Darts501’s Yorkshire page also describes a single 50 bull with no outer bull.
- Colours varied. Darts501 describes Yorkshire boards with black, red, green and natural beds. The all-black finish is more typical of the Irish Black and Kent boards.
- Size is not standard. Sources give different sizes. One specialist page gives 13¼ inches, so measure a board before assuming it matches a regulation board.
How it is played
Rules vary by league. Darts501’s Yorkshire rules say that games were generally started and finished with a double, and that competition games usually use a straight start with a double to finish. The order of play is set by a toss or by bulling up: each player throws at the bull, and the nearer one throws first.
Setup: one source’s figures
Darts501 gives a different setup for the Yorkshire board. It puts the bull centre at 1.676 m (5 ft 6 in) above the floor, with a throw line 2.184 m (7 ft 2 in) from the board face. It also says some players set the board up the same as a standard board. These figures do not match the standard distances, so check your league’s rules before setting one up.
Where it is still played
Chaplin’s 2012 article named a league in Bradford and the Dales Darts League in North Yorkshire, along with pubs where the board was still in use. Those listings are more than a decade old, so check before you visit. Yorkshire boards are uncommon now. Most turn up second-hand, or in a few local leagues.
Old boards: value and care
- Value: the price of an old board depends on the maker, its age, its condition and whether it is complete. A reliable figure needs recent sold listings or a dealer who handles old darts equipment.
- Keeping one: store it dry, check for loose or bent wire, and rotate it to spread wear. Ask a specialist before treating a wooden board, since methods vary.
- Letting one go: check whether a local pub, club or league still plays on Yorkshire boards. If not, follow your local rules for disposing of wood and steel.
For a shorter answer to whether these boards still exist, see is there such a thing as a Yorkshire dartboard. The rings and bullseye guide explains the standard rings that the Yorkshire board does without.