How to look after a dartboard
The routine is simple. Rotate the board regularly, remove darts gently, keep the board dry and away from heat, and keep your dart points smooth. Mould comes from damp, so fix the damp before you clean.
Rotate the board regularly
Rotate the board every few weeks, or sooner after heavy play. This moves wear away from the 20 and treble 20, which take the most hits.
- If the board has a removable number ring, take the ring off, rotate the board itself, and refit the ring with 20 at the top.
- Re-level the board after rotating, so it sits straight on the wall.
- Turning only the number ring doesn’t spread wear, because the sisal and wires stay where they are.
Remove darts without tearing the sisal
- Twist gently as you pull a dart out. Don’t yank it or lever it sideways.
- Keep the points smooth and rounded. Burred or hooked points tear the fibres. A dart sharpener helps.
- Don’t sharpen points to a needle. That also cuts the fibres.
- Push loose fibres back in with a finger. Don’t pull them out.
- Use steel-tip darts only on bristle boards. Soft-tip darts don’t belong on a bristle board.
Keep it dry and away from heat
- Store the board in a dry, ventilated room at normal room temperature.
- Avoid damp garages, cellars and bathrooms.
- Keep the board out of direct sunlight, and away from radiators and heaters.
- A cabinet helps with dust and light, but it won’t stop mould in a damp room.
- Don’t spray or soak the board to “close the holes”. Water swells sisal and damages the fibres.
Check the fittings
Every so often, check the wire fixings and the bullseye for loose or damaged parts. Make sure the board is level and secure on the wall.
How to clean mould off a dartboard
Mould is a sign of damp, so start by moving the board to a dry, ventilated room. Then clean it:
- Protect yourself. Wear a mask and gloves, and work outdoors in the shade.
- Brush it off. Use a stiff, dry brush to sweep away the mould and loose residue.
- Wipe lightly if needed. Some people use a barely damp cloth with diluted white vinegar or isopropyl alcohol on any staining. Results vary, so test an inconspicuous area first. Never soak the board.
- Dry it fully. Let it dry slowly at room temperature in a ventilated room. Don’t use a hairdryer or heater, because fast drying can crack the board.
Avoid these:
- Soaking the board, or spraying it with water
- Bleach and household sprays, which soak into the fibres
- Leaving the board in direct sun for long periods to dry it, which can fade and dry it out
If mould has gone deep into the board or keeps coming back, replace the board. Keep children away while you clean.
When to replace the board
Replace the board when holes stay open after darts are removed, fibres break away, darts bounce out often, or wires are loose or bent. A worn treble 20 that doesn’t recover after rotation is another sign. For more on lifespan, see how long a dartboard lasts.
For a board that holds up well to regular play, see the best bristle dartboards. If your board lives outside or in a garage, read our outdoor dartboard guide.