Board Setup

How far is it from dart Board?

The throw distance is 2.37 m (7 ft 9¼ in) for steel tip, measured from the board face. Soft tip is usually 2.44 m (8 ft). Here is how to check it.

On this page
  1. The short answer
  2. How to measure it
  3. The diagonal check
  4. Men, women and juniors
  5. Room length
  6. Older and local distances
  7. Mistakes to avoid

The short answer

For steel-tip darts, the throw distance is 2.37 m (7 ft 9¼ in). Measure it horizontally, along the floor, from the face of the board to the front edge of the oche. Soft-tip boards usually use 2.44 m (8 ft), but leagues and machine operators can set it differently.

How to measure it

  • Measure from the board face, not the wall. A bristle board is about 38 mm (1½ in) thick, so a measurement from the wall will be off.
  • Keep the line square to the board. A line that angles away from the board changes the distance across the throw.
  • Measure from a point on the floor directly below the bull. If the board hangs plumb, that point lines up with the face.

The oche distance guide covers where to stand once the line is marked.

The diagonal check

The diagonal from the centre of the bull to the front of the oche, measured at floor level, is a useful check. For steel tip it is about 2.93 m (9 ft 7⅜ in). For soft tip it is about 2.99 m (9 ft 9⅝ in).

The diagonal checks the height and the distance together. You can confirm the steel-tip figure with Pythagoras: √(2.37² + 1.73²) ≈ 2.93 m. The diagonal is a check, not the line you mark on the floor.

Men, women and juniors

The same throw distance applies to men, women and juniors under WDF and PDC rules. Some local youth leagues use a shorter line, so check the rules where you play.

Room length

Allow about 10 to 11 ft (3 to 3.4 m) of room length, including the space behind the oche for your stance and step back. The space guide covers width and ceiling height too.

Older and local distances

Older pub distances of 7 ft, 7 ft 6 in, 8 ft and 9 ft still turn up. 7 ft 9¼ in is now the standard. Some pages quote 8 ft for steel tip, usually from other organisations’ rules, so check the rules of your league before you mark the line.

Mistakes to avoid

  • Measuring from the wall. Start at the board face.
  • Thinking 8 ft is the steel-tip standard. The standard is 2.37 m (7 ft 9¼ in). Check your league if you see 8 ft quoted.
  • Thinking women throw from a shorter line. The distance is the same.
  • Treating the diagonal as the floor distance. The diagonal is a check. The floor line is the horizontal distance.

For the bull height that goes with this distance, see the dartboard height guide. The full sequence is in the dartboard setup guide.

The complete guide to board setup

How to Set Up a Dartboard: Height and Throwing Distance
Read the guide

Keep exploring

Guides from other topics

All topics →