Board Setup

How to Fix a Dartboard to a Brick or Concrete Wall

Fix a dartboard to brick or concrete with a masonry bit, correctly sized plugs and screws. Set the bull at 1.73 m and protect the wall from missed darts.

On this page
  1. The short answer
  2. Tools you need
  3. Match the bit to the plug
  4. Drill into brick, not mortar
  5. Drill depth and clearing dust
  6. Plastered brick
  7. Fix the bracket and set the bull height
  8. Protect the wall
  9. Safety
  10. Mistakes to avoid

The short answer

Brick and concrete are strong walls for a dartboard. Drill with a masonry bit, fit plugs that match the bit, and fix the bracket so the bull sits at 1.73 m (5 ft 8 in). Then protect the wall, because darts that miss brick bounce and blunt.

Tools you need

  • A hammer drill, or a combi drill on its hammer setting
  • A masonry bit sized to your plugs
  • Wall plugs and screws suited to the bracket
  • A spirit level and a tape measure
  • Eye protection and a dust mask

Concrete is harder than brick. Use a sharp SDS or masonry bit and the hammer setting.

Match the bit to the plug

Check the drill size printed on the plug packet, and use a bit of that size. Do not guess the size from the colour of the plug. Screws are often 4 to 5 mm (8 or 10 gauge), but check what your bracket kit specifies.

Drill into brick, not mortar

Drill into the brick itself, not the mortar joints. Mortar holds less reliably than solid brick, so a fixing placed in a joint can work loose over time. If your bull mark falls on a joint, move the bracket slightly so the fixing sits in the brick.

Drill depth and clearing dust

Drill a little deeper than the plug is long. A depth of about 30 to 50 mm is typical, so the plug sits flush. Before you push the plug in, blow or vacuum the dust out of the hole. Dust left in the hole stops the plug from gripping.

Plastered brick

If the brick is plastered, drill through the plaster and into the brick behind it. Plaster on its own does not hold a fixing, so the plug needs to reach solid brick.

Fix the bracket and set the bull height

Mark the bull at 1.73 m (5 ft 8 in) from the floor, then fix the centre bracket so the bull sits at that height. Check that the bracket is level before you tighten it. Fit the stabilising brackets at the edge of the board so it cannot rotate. The dartboard height guide explains why the bracket and the bull are at different heights.

Protect the wall

Darts that miss brick bounce off and can blunt their points, and the wall takes the impact. A surround or a backboard protects the brick and the darts. For options, see what to put behind a dartboard.

Safety

  • Wear eye protection when drilling masonry, and a dust mask for concrete dust.
  • Use a cable detector before drilling, and avoid the lines above and below sockets and switches.
  • Take care with the hammer setting on a drill. It can break through thin plaster quickly.

Mistakes to avoid

  • Using a standard drill setting for brick or concrete. You need the hammer setting and a masonry bit.
  • Using plugs that do not match the bit. The fixing will not hold.
  • Assuming mortar is the better place to drill. Solid brick is better.
  • Assuming masonry needs no backing. The brick will not dent, but the darts will still bounce and blunt.

For plasterboard walls, see fixing to plasterboard. The full setup is in the dartboard setup guide.

The complete guide to board setup

How to Set Up a Dartboard: Height and Throwing Distance
Read the guide

Keep exploring

Guides from other topics

All topics →