Yes, you can hang a dartboard without a drill
You can hang a dartboard without a drill, but you still need a stable mount, the right height and the right throw distance. The safest no-drill options are a freestanding stand and an over-door hanger. A few other methods can work for lighter boards or specific walls.
Option 1: a freestanding stand
A freestanding stand needs no wall fixing. Most set the bull at 1.73 m (5 ft 8 in), though some are adjustable and some are fixed lower, so check the height before you buy. Many fold away, which helps if you need to move the board.
Check that the base is stable and weighted, so the stand cannot tip onto someone. Test it by pressing on the board before you throw.
Option 2: an over-door hanger
An over-door hanger hooks over the top of a door, and the board hangs on the face of the door. It works well for a solid door. Check that the door can take the weight, that it closes properly and that nothing hits the frame when it moves. The full steps are in the door hanging guide.
Option 3: a hammer-in hook
Some hardwall or picture hooks go in with a hammer, not a drill. They suit light boards only. Their load ratings vary, so check the rating against the board’s weight before you hang anything. A board that hits the hook with every throw puts more strain on it than a picture does.
Option 4: a screwdriver fix into timber
On a stud or a solid timber surface, a bracket can often be fixed with a screwdriver. A pilot hole is optional in softer wood, but it is still wise to check the screw bites into solid timber. Do not use this on bare plasterboard alone; see the plasterboard guide.
A lighter board suits no-drill setups
Paper, coiled-paper, magnetic and electronic boards are lighter than a bristle board, so they suit low-load hanging better. Electronic boards also often have a keyhole slot on the back, which makes them easier to hang on a simple hook. Check the manufacturer’s weight rating before you decide.
What does not work
- Adhesive hooks and strips. They are not made for dartboard loads. A board that is hit by darts puts a shearing force on the adhesive, and the strips can let go.
- Leaning a board on a shelf. It tips or slides when a dart hits it.
- Skipping the height and distance. A temporary setup still needs the bull at 1.73 m and the throw line at 2.37 m for steel tip. See the dartboard setup guide.
Still set the height and distance
Whatever you use, measure the bull at 1.73 m from the floor. Mark the throw line at 2.37 m from the board face for steel tip, or 2.44 m for soft tip. The oche distance guide explains where to stand.
Keep the board steady as well. A moving board deflects darts and can damage the wall behind it. If it swings when you touch it, add a second point of support or move to a stronger option.
Safety
- Make sure the stand’s base is stable and weighted.
- Do not use an over-door hanger while anyone could open the door. Lock the door or block access from the other side during play.
- Keep the area behind the board clear, because darts that miss can travel further than you expect.
For wall protection behind the board, see what to put behind a dartboard.