Board Setup

Can you put a surround on a darts stand?

Usually yes. Most stands take a surround as a wall board does, but check the upright clearance, the added weight and the base before you throw.

On this page
  1. The short answer
  2. Check the clearance first
  3. Fit the surround
  4. Keep the stand steady
  5. Check the height and distance afterwards
  6. Stands that come with a surround
  7. Mistakes to avoid

The short answer

Usually, yes. Most darts stands hold a standard bristle board on the usual centre bracket, so a surround fits the same way it would on a wall. Before you buy one, check the stand’s clearance, the added weight and the compatibility with the surround.

Check the clearance first

A surround’s outer diameter is roughly 28 to 30 in (71 to 76 cm). Measure the space between the upright or arms of the stand and the edge of the board. A one-piece surround can catch on the uprights, so check the clearance before you push it on. A segmented surround is usually easier to fit around a stand, because each piece can be clipped on separately.

Fit the surround

Fitting a one-piece surround on a stand follows the same pattern as on a wall:

  1. Remove the board from the stand’s bracket.
  2. Push the surround over the edge of the board.
  3. Remount the board on the stand bracket.

Check that the surround sits flat against the board with no gaps where darts could lodge.

Keep the stand steady

A surround adds weight high up on the stand, which raises the centre of gravity. A stand with a wide or weighted base is more stable. Some stands accept sandbags or other weights on the base. Test the stand by pressing gently on the board with the surround fitted, before anyone throws.

If the stand wobbles with the surround on, add weight to the base or move the stand to a flat floor.

Check the height and distance afterwards

Remounting the board can change the bull height, so measure it again. The bull should sit at 1.73 m (5 ft 8 in) from the floor. The surround does not change the regulation figures, but the stand’s bracket might. The throw distance is measured from the face of the board, which is 2.37 m for steel tip and usually 2.44 m for soft tip. See the dartboard height guide for the bull measurement.

Stands that come with a surround

Some stands include an integrated surround, a backboard panel, dart holders, LED light rings or oche markers. If your stand already has a surround, you may not need a separate one. Check the manufacturer’s listing before you buy, because compatibility varies by stand and surround brand.

Mistakes to avoid

  • Assuming every surround fits every stand. Check the clearance and the manufacturer’s listing.
  • Assuming a stand needs no protection because it is not on a wall. Stray darts still hit the floor and the surrounding walls, so a surround helps. See what to put behind a dartboard.
  • Assuming a surround changes the regulation height or distance. It does not. Measure after fitting.

For a wall-mounted board, the cabinet and surround guide covers the same fitting steps. The full setup is in the dartboard setup guide.

The complete guide to board setup

How to Set Up a Dartboard: Height and Throwing Distance
Read the guide

Keep exploring

Guides from other topics

All topics →