Short answer: unscrew, fit by hand, align, and replace worn parts
Most flights and shafts use a 2BA thread. Unscrew the shaft anticlockwise, then screw the new one in clockwise by hand. Fit the flight so its wings sit at even angles. Replace any part that is damaged, and change the parts on all three darts together so the set stays matched.
What you need
- Replacement shafts. Check the length and thread.
- Replacement flights that match the type you use, whether standard push-in or a locking system.
- Optional: an O-ring and a flight ring or protector.
- For a broken thread: a shaft-extraction tool or a small screw-in extractor.
Don’t use pliers to tighten a shaft. They can crush it.
Safety first
Hold the dart by the barrel, with the point away from your hand, while you work on it.
Step 1: Remove the shaft
Unscrew the shaft anticlockwise by hand. If it is tight, don’t force it with pliers.
Step 2: Fit the shaft
- Slip an O-ring over the shaft thread before you screw it in. It reduces loosening, which is especially useful with aluminium shafts.
- Screw the new shaft in clockwise, by hand.
- Tighten finger-tight only. Overtightening is the most common cause of snapped nylon threads.
- Don’t use thread-locking glue. It isn’t needed, and it makes future removal hard.
Step 3: Fit the flight
For a standard push-in flight:
- Fold the flight into an X shape.
- Push all four wings evenly into the shaft slots.
- Push the flight fully down, so it seats at the bottom of the slots.
- Align the wings at even 90° angles. A bent flight changes the flight path.
- Fit a flight ring, protector or spring if your set uses one, to stop the flight falling out.
Locking systems, such as L-Style, Fit Flight and Cosmo, click only into matching shafts. Don’t try to force them onto other shafts.
Step 4: Test the dart
Throw a few darts and check that the flight tracks straight. If a dart wobbles, check the alignment and seating of the flight first.
Broken thread in the barrel
If the shaft’s thread breaks inside the barrel, remove it with a shaft-extraction tool or a small screw-in extractor. Pliers are not the right tool for this.
When to replace
- Flights: replace any flight that is bent, split or creased, or that no longer grips in the slots.
- Shafts: replace a shaft with a cracked top, or one whose slots no longer hold the flight.
- Aluminium shafts: check them every few legs, because they loosen during play.
A loose flight isn’t always worn. Sometimes the shaft’s slots have widened, so check the slots before you buy new flights.
Keep the set matched
Change the shafts and flights on all three darts together. Match the shaft lengths, rather than the brand names. Shaft lengths vary between brands, so compare the millimetre figures on the listing.
For a fuller look at the materials and lengths, see dart shafts explained. For the shapes, see dart flight shapes.
Common misconceptions
- Don’t assume a shaft will fit because the brand matches. Check the thread and the length.
- Overtightening causes most snapped threads, not poor quality.
- A loose flight may mean widened slots, not just wear.